Bison Power Rasin Adhesive, 6305493, 65ML, Beige

Product description

Universal dual-component polyurethane adhesive, for the most difficult joints

Bonds many materials where other adhesives fail, such as metal, iron, stainless steel, aluminium, zinc, concrete, stone, marble, ceramic wall and floor tiles, wood, glass, rubber and many synthetics. Especially suitable for adhesive bonding of synthetics material with other materials. Not suitable for for bonding Polyethylene (PE), Polypropylene (PP), PTFE and silicone.

It is recommended that rubber or plastic gloves are worn.

Surface requirements

The surface must be clean, dry, free of dust and grease.

If necessary, degrease with Bison Degreaser or acetone. With smooth surfaces light sanding provides a stronger bond.

The adhesive consists of two components: Resin and hardener. Press gently out both tubes two equally long lines of product. This way you get exactly the correct mixture ratio of resin and hardener (4 vol. parts resin to 1 vol. part hardener). Mix both components thoroughly with the supplied spatula into a mass of homogeneous color. The adhesive mix, depending on the temperature and the nature of the material, remains workable for about 15 minutes. Apply the adhesive mixture on one side of the substrate or the materials to be bonded, join the parts and keep them firmly in place (preferably clamp or support). Remove excess adhesive immediately with a cloth.

Remove adhesive residue immediately with acetone. Dry adhesive residue can only be removed mechanically.

Advice

Some types of synthetics can not be joined such as polyethylene and polypropylene. This can be tested by holding a glowing copper wire against the synthetics. Does it smell of wax? Then you can not bond it. Use a piece of adhesive tape in order to keep the parts in place while the adhesive is curing.

• Final bond strength: Approx. 1800 N/sq.cm
• For the toughest connections
• (Sea)water resistant
• Cold and heat resistant between -30 to +100 Deg.C